Teledyne 300m User Manual download pdf (Page 31)

Teledyne API Model 300M CO Analyzer Instruction Manual, 04033, Rev. A

Table 2-2: System Modes

Mode Meaning

SAMPLE x (1) Sampling normally

SAMPLE x (1) Flashing indicates adaptive filter is on

ZERO CAL x (2) Doing a zero check or adjust

SPAN CAL x (2) Doing a span check or adjust

MP CAL Doing a multi-point calibration

SETUP xxx (3) Configuring analyzer (sampling continues)

DIAG DAS (4) Data Acquisition configuration

DIAG I/O (4) Test digital I/O signals

DIAG AOUT (4) Test analog output channels

DIAG D/A (4) Configure and Calibrate Digital to Analog converters

DIAG TCHN (4) Configure Test Channel output

(1) x = A (auto)

(2) x = M (manual), A (auto), R (remote)

(3) xxx = software revision (e.g. A.9)

(4) diagnostic test modes

The message field shows test measurements or warning messages. Table 2-3 and Table 2-4

summarize the test measurements and warning messages and their meanings. Refer to Sections 4

and 5 for detailed information on viewing test measurements and warning messages and clearing

warnings.

2-5

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 122 123

No comments

Teledyne 300m User Manual Page 31