Teledyne Marine Instruments 2002 User Manual download pdf (Page 29)

149-072011 Model 2002 Vacuum Gauge Page 29 of 38

8. 4-20 mA Interface Option Board

The Relay option board in the Model 2002 operates off of the set points defined by the user and

programmed into the Model 2002 microprocessor. For more information about configuring these set points

refer to Section 3 of this manual.

The 4-20 mA interface board is available as an option for the Model 2002. This board provides dual current

channels linearly proportional to the HPM 2002’s pressure reading. Please note that use of the Model 2002

with this option requires a CPU with firmware for version 1.6 or later.

8.1. 4-20 mA Interference

Connector Pin Assignments

Pin Connection

1.............................................................................................................Internal loop power out (+) channel 1.

3...................................................................................................................................... Loop in (-) channel 1.

8.............................................................................................................Internal loop power out (+) channel 2.

7...................................................................................................................................... Loop in (-) channel 2.

The 4-20 mA board can only be operated with internal loop power.

A schematic (Figure 8.2) is attached to show the proper method to wire into a loop.

Symptom: Fixed display, regardless of pressure

Action: 1. Check sensor for contamination.

Model 2002

Rear Panel Detail

Fig 8.1

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 37 38

Comments to this Manuals

No comments

Teledyne Marine Instruments 2002 User Manual Page 29

Comments to this Manuals

Related products and manuals for Measuring, testing & control Teledyne Marine Instruments 2002