Teledyne 6600 User Manual Page 12
- Page / 151
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
1-4: Part I
1 Introduction Model 6600
Teledyne Analytical Instruments
Figure 1-1: Model 6600 Controls, Indicators, and Connectors
.
Digital Meter Display: The meter display is a Light Emitting Diode
LED device that produces large, bright, 7-segment numbers that are legible
in any lighting. It is accurate across all analysis ranges. The 6600 models
produce continuous readout from 0-10,000 ppm and then switch to
continuous percent readout from 1-100 %.
- Model 6600 1
- Model 6600 2
- Oil in Water Analyzer 3
- Part I: iii 7
- Introduction 9
- 1.4 Operator Interface 10
- Part I: 1-5 13
- Installation 15
- 2-2: Part I 16
- Part I: 2-3 17
- 2-4: Part I 18
- Part I: 2-5 19
- 2-6: Part I 20
- Part I: 2-7 21
- Table 2-3: RS-232 Signals 21
- 2-8: Part I 22
- Part I: 2-9 23
- 2.3 Testing the System 23
- 2-10: Part I 24
- Operation 25
- 3-2 Part I 26
- Part I 3-3 27
- 3-4 Part I 28
- 3.3 The System Function 28
- Part I 3-5 29
- 3-6 Part I 30
- Part I 3-7 31
- 3-8 Part I 32
- Part I 3-9 33
- 3-10 Part I 34
- Part I 3-11 35
- 3-12 Part I 36
- Part I 3-13 37
- 3-14 Part I 38
- Part I 3-15 39
- 3-16 Part I 40
- Part I 3-17 41
- 3-18 Part I 42
- Part I 3-19 43
- 3-20 Part I 44
- Part I 3-21 45
- 3-22 Part I 46
- 3.5 The Alarms Function 46
- Part I 3-23 47
- 3-24 Part I 48
- Part I 3-25 49
- 3-26 Part I 50
- Part I 3-27 51
- 3.7 The Analyze Function 51
- 3-28 Part I 52
- 3.8 Programming 52
- Part I 3-29 53
- 3-30 Part I 54
- Part I 3-31 55
- UP/DOWN key to 55
- 3-32 Part I 56
- Maintenance 57
- 4-2: Part I 58
- Part I: 4-3 59
- 4.3 Major Internal Components 59
- 4-4: Part I 60
- Part II: iii 63
- Operational Theory 65
- 1-2 Part II 66
- 1.2 Optical Bench 66
- Part II: 1-3 67
- 1.3 Photometer Amplifier 67
- 1-4 Part II 68
- 1.4 Automatic Zero System 68
- Part II: 1-5 69
- 1.5 System Description 69
- 1-6 Part II 70
- 1.6 Photometer 70
- Part II: 1-7 71
- 1-8 Part II 72
- 1.7 Sample Systems 72
- 2-2: Part II 74
- Part II: 2-3 75
- 2.4 Calibration 75
- 2.4.1 Calibration Fluids 75
- 2-4: Part II 76
- 3-2 Part II 78
- Part II 3-3 79
- 3-4 Part II 80
- Part II 3-5 81
- 3-6 Part II 82
- Part II 3-7 83
- 3-8 Part II 84
- Part II 3-9 85
- 3-10 Part II 86
- Part III: iii 89
- Part III: 1-1 91
- 1.0 Introduction 91
- 1-2 Part III 92
- 2.0 The Method of Analysis 92
- 2.1 The Optical Bench 92
- 2.2 The Photometer Amplifier 92
- Part III: 1-3 93
- 1-4 Part III 94
- 2.3 The Automatic Zero System 94
- Part III: 1-5 95
- 1-6 Part III 96
- Part III: 1-7 97
- 1-8 Part III 98
- 3.0 System Description 98
- Part III: 1-9 99
- 3.1 Photometer 99
- 3.1.1 Source Module 99
- 3.1.2 Sample Cell 99
- 1-10 Part III 100
- Model 6600 100
- 3.1.3 Detector Module 100
- 3.1.4 Control/Analysis Unit 100
- Part III: 1-11 101
- 3.3 Electrical Connections 101
- 3.4 The Sampling System 101
- 1-12 Part III 102
- Part III: 1-13 103
- Homogenizing 103
- 1-14 Part III 104
- Part III: 1-15 105
- 1-16 Part III 106
- 3.5 The Signal Outputs 106
- 3.6 Recorder Requirement 106
- Part III: 1-17 107
- 3.7 The Process Alarm System 107
- 3.8 The amplifier PCB 107
- 3.8.1 Auto Zero Circuit 107
- 1-18 Part III 108
- 3.8.2 Signal Failure Alarm 108
- Part III: 1-19 109
- 4.0 INSTALLATION 109
- Part III: 1-21 111
- 4.1.5 Sample Delivery System 111
- 4.1.6 Safe Vent (Drainage) 111
- 1-22 Part III 112
- 5.1 Installation Check 112
- 5.2 Electronics Check 112
- Part III: 1-23 113
- 5.3 Electrical Check 113
- 5.4 Sample Delivery Check 113
- 1-24 Part III 114
- Part III: 1-25 115
- 1-26 Part III 116
- Part III: 1-27 117
- 1-28 Part III 118
- Part III: 1-29 119
- 5.6.1 Zero Fluid Preparation 119
- 5.6.2 Span Fluid Preparation 119
- 1-30 Part III 120
- 5.6.3 Calibration 120
- Part III: 1-31 121
- 1-32 Part III 122
- Analysis 122
- Part III: 1-33 123
- homogenizer 124
- Part III: 1-35 125
- CORRELATION 125
- 1-36 Part III 126
- OPERATIONAL DUTIES 126
- Part III: 1-37 127
- 6.2 Routine Maintenance 127
- 1-38 Part III 128
- (Application dependent) 128
- Part III: 1-39 129
- 7.0 SERVICE PROCEDURES AND 129
- ADJUSTMENTS 129
- End Amplifiers 129
- 1-40 Part III 130
- Part III: 1-41 131
- 7.4 The Inverting Amplifier 131
- 1-42 Part III 132
- 7.6 Sample Cell Maintenance 132
- Part III: 1-43 133
- 7.7 Sample System Maintenance 133
- 7.8 Zero Filter Replacement 133
- 1-44 Part III 134
- Part III: 1-45 135
- 7.10 Lamp Replacement 135
- 7.11 Phototube Replacement 135
- Part III: 1-47 137
- 8.2.2 Sample Pump Failure 137
- 8.3 Zero Drift Problems 137
- 1-48 Part III 138
- Part III: 1-49 139
- 1-50 Part III 140
- Oil in Water Part III 141
- 1-52 Part III 142
- (see addendum 142
- (see addendum drawings) 142
- Part III: 1-53 143
- 1-54 Part III 144
- Part III: 1-55 145
- 1-56 Part III 146
- Part III: 1-57 147
- Appendix 148
- (non freezing, non-boiling) 149
- Model 6600 150
- Generic Drawing List 151
© 2020, manymanuals.com. All rights reserved. | 0.560 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals