Teledyne 6750 User Manual download pdf (Page 43)

Total Organic Carbon Analyzer Setup and Operation

Teledyne Analytical Instruments 31

Figure 4-2: Gas Liquid Separator D. I. Filling

After reagents and DI have filled all tubing lines, it is

recommended to proceed with IR Calibration followed by cal (liquid

calibration) of the system. Then the analyzer may be placed in service.

4.2 Menus

The advanced design of the Model 6750 TOC Analyzer eliminates

complicated, routine, and sometimes confusing menus. The

operator/software interface is simple and easy to use. Menus prompt the

user for required actions or input.

The analyzer has no manual adjustments. All calibrations and

operations are computer controlled by the operator following menu

prompting and selection of the operation of choice.

The following menu and operation descriptions are intended to

guide the operator through all the functions of the analyzer.

After primary power (110/220VAC) has been applied to the

analyzer and self-diagnostic procedure has been completed, the system

automatically boots up to the following RUN Screen. If not, turn main

power OFF, then ON to reboot.

4.2.1 Run Mode

RUN – This is the normal analysis mode. In this mode, the display

indicates:

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 95 96

No comments

Teledyne 6750 User Manual Page 43